Phone: 913-492-0495
Email: info@interactivedesign.com

Cast Aluminum Part Inspection

3D Part Inspection on Cast Aluminum Parts

Automation requirements:

  • Gauging the outside diameter of the part
  • Determination if a bent end condition exists at the open end of the part
  • Identifying broken parts, short fills, light de-laminations, and porosity defects on the outside surfaces of the part
  • Identifying lamination and break back in the interior of the part
  • Reading the cavity identification number
  • Porosity Inspection, reject part if:
    • Any hole is larger than .020” in diameter
    • There are more than 5 holes, less than .020” in diameter each
    • Any two holes are closer than .100”
MORE IMAGES
PLAY VIDEO